Measurements of capture cross-section of Nb by activation method and half-life of Nb by mass analysis

Nakamura, Shoji; Shibahara, Yuji*; Endo, Shunsuke; Kimura, Atsushi

Journal of Nuclear Science and Technology, 60(11), p.1361 - 1371, 2023/11

https://doi.org/10.1080/00223131.2023.2198526

The thermal-neutron capture cross section () and resonance integral (I) for Nb among nuclides for decommissioning were measured by an activation method and the half-life of Nb by mass analysis. Niobium-93 samples were irradiated with a hydraulic conveyer installed in the research reactor in Institute for Integral Radiation and Nuclear Science, Kyoto University. Gold-aluminum, cobalt-aluminum alloy wires were used to monitor thermal-neutron fluxes and epi-thermal Westcott's indexes at an irradiation position. A 25-m-thick gadolinium foil was used to sort out reactions ascribe to thermal-and epi-thermal neutrons. Its thickness provided a cut-off energy of 0.133 eV. In order to attenuate radioactivity of Ta due to impurities, the Nb samples were cooled for nearly 2 years. The induced radio activity in the monitors and Nb samples were measured by -ray spectroscopy. In analysis based on Westcott's convention, the and I values were derived as 1.110.04 barn and 10.50.6 barn, respectively. After the -ray measurements, mass analysis was applied to the Nb sample to obtain the reaction rate. By combining data obtained by both -ray spectroscopy and mass analysis, the half-life of Nb was derived as (2.000.15)10 years.

Thermal-neutron capture cross-section measurements of neptunium-237 with graphite thermal column in KUR

Nakamura, Shoji; Shibahara, Yuji*; Endo, Shunsuke; Kimura, Atsushi

Journal of Nuclear Science and Technology, 59(11), p.1388 - 1398, 2022/11

https://doi.org/10.1080/00223131.2022.2058639

The present study selected Np among radioactive nuclides and aimed to measure the thermal-neutron capture cross-section for Np in a well-thermalized neutron field by an activation method. A Np standard solution was used for irradiation samples. A thermal-neutron flux at an irradiation position was measured with neutron flux monitors: Sc, Co, Mo, Ta and Au. The Np sample and flux monitors were irradiated together for 30 minutes in the graphite thermal column equipped with the Kyoto University Research Reactor. The similar irradiation was carried out twice. After the irradiations, the Np samples were quantified using 312-keV gamma ray emitted from Pa in a radiation equilibrium with Np. The reaction rates of Np were obtained from gamma-ray peak net counts given by Np, and then the thermal-neutron capture cross-section of Np was found to be 173.84.4 barn by averaging the results obtained by the two irradiations. The present result was in agreement with the reported data given by a time-of-flight method within the limit of uncertainty.

Development of the unified cross-section set ADJ2017R

Yokoyama, Kenji; Maruyama, Shuhei; Taninaka, Hiroshi; Oki, Shigeo

JAEA-Data/Code 2021-019, 115 Pages, 2022/03

JAEA-Data-Code-2021-019.pdf:6.21MB
JAEA-Data-Code-2021-019-appendix(CD-ROM).zip:435.94MB

In JAEA, several versions of unified cross-section set for fast reactors have been developed so far; we have developed a new unified cross-section set ADJ2017R, which is an improved version of the unified cross-section setADJ2017 for fast reactors. The unified cross-section set is used for reflecting information of C/E values (analysis / experiment values) obtained by integral experiment analyses in reactor core design via the cross-section adjustment methodology; the values are stored in the standard database for FBR core design. In the methodology, the cross-section set is adjusted by integrating the information such as uncertainty (covariance) of nuclear data, uncertainty of integral experiment / analysis, sensitivity of integral experiment with respect to nuclear data. ADJ2017R basically has the same performance as ADJ2017, but we conducted an additional investigation on ADJ2017 and revised the following two points. The first is to unify the evaluation method of the correlation coefficient of uncertainty caused by experiments (hereinafter referred to as the experimental correlation coefficient). Because it was found that the common uncertainty used in the evaluation of the experimental correlation coefficient was evaluated by two different methods, the experimental correlation coefficients were revised for all experimental data, and the evaluation method was unified. The second is the review of the integral experiment data used for the cross-section adjustment calculation. It was found that one of the experimental values of composition ratio after irradiation of the Am-243 sample has a problem in uncertainty evaluation because its experimental uncertainty is extremely small compared to the others. The cross-section adjustment calculation was, therefore, redone by excluding the experimental value. In the creation of ADJ2017, a total of 719 data sets were analyzed and evaluated, and eventually adopted 620 integral experimental data sets. In contrast, a total of 61

KeV-region analysis of the neutron capture cross-section of Np

Rovira Leveroni, G.; Katabuchi, Tatsuya*; Tosaka, Kenichi*; Matsuura, Shota*; Kodama, Yu*; Nakano, Hideto*; Iwamoto, Osamu; Kimura, Atsushi; Nakamura, Shoji; Iwamoto, Nobuyuki

Journal of Nuclear Science and Technology, 59(1), p.110 - 122, 2022/01

https://doi.org/10.1080/00223131.2021.1954104

Bias effects on g- and s-factors in Westcott convention

Harada, Hideo

Applied Sciences (Internet), 11(14), p.6558_1 - 6558_20, 2021/07

https://doi.org/10.3390/app11146558

For accuracy improvement of neutron activation analysis and neutron capture cross section, bias effects are investigated on g- and s-factors in the Westcott convention. As origins of biases, a joining function shape, neutron temperature and sample temperature, have been investigated. Biases are quantitatively deduced for two 1/v isotopes (Au, Co) and six non-1/v isotopes (Am, Eu, Rh, In, Hf, Ra). The s-factor calculated with a joining function deduced recently by a detailed Monte Carlo simulation is compared to s-factors calculated with traditional joining functions by Westcott. The results show the bias induced by sample temperature is small as the order of 0.1% for g-factor and the order of 1% for s-factor. On the other hand, biases induced by a joining function shape for s-factor depend significantly on both isotopes and neutron temperature. As the result, reaction rates are also affected significantly as well. The bias size on reaction rate is given in the case of epithermal neutron index r = 0.1, for the eight isotopes.

Thermal-neutron capture cross sections and resonance integrals of the Am(n,)Am and Am(n,)Am reactions

Nakamura, Shoji; Shibahara, Yuji*; Endo, Shunsuke; Kimura, Atsushi

Journal of Nuclear Science and Technology, 58(3), p.259 - 277, 2021/03

https://doi.org/10.1080/00223131.2020.1819907

Research and development were made for accuracy improvement of neutron capture cross section data on Am among minor actinides. First, the emission probabilities of decay rays were obtained with high accuracy, and the amount of the ground state of Am produced by reactor neutron irradiation of Am was examined by -ray measurement. Next, the total amount of isomer and ground states was examined by -ray measurement. Thermal-neutron capture cross sections and resonance integrals were derived both for the Am(n,)Am and for Am(n,)Am reactions.

Measurement of cesium isotopic ratio by thermal ionization mass spectrometry for neutron capture reaction studies on Cs

Shibahara, Yuji*; Nakamura, Shoji; Uehara, Akihiro*; Fujii, Toshiyuki*; Fukutani, Satoshi*; Kimura, Atsushi; Iwamoto, Osamu

Journal of Radioanalytical and Nuclear Chemistry, 325(1), p.155 - 165, 2020/07

https://doi.org/10.1007/s10967-020-07198-2

The measurements of isotopic ratios of Cs samples by thermal ionization mass spectrometry were performed for the analysis of their samples used to evaluate nuclear data obtained for Cs. To obtain a high intensity and stable ion beam, the effects of additive agents on the ionization of Cs were examined. The effect of silicotungstic acid on the ionization of Cs was the largest among the additive agents studied in the present study, while the silicotungstic acid also showed the largest isobaric interference of polyatomic ions. It was demonstrated that as small as 210 g of a Cs sample was sufficient to achieve the analytical precision required to measure the Cs/Cs ratio in the case where an additive agent of TaO/glucose was employed. After examining of the analytical conditions, such as the interference effect due to Ba, the measurements of the isotopic ratios of two Cs samples used in our study using TIMS were conducted, and it was discussed how much the ratios contributed to evaluation of the neutron capture cross-section of Cs.

Survey of computational methods of cross sections for thermal neutron scattering by liquids

Ichihara, Akira

JAEA-Review 2019-046, 36 Pages, 2020/03

JAEA-Review-2019-046.pdf:1.55MB

Toward the revision of JENDL-4.0, we conducted a literature survey on how to compute the cross section of thermal neutrons scattered by a liquid. This report summarizes the computational methods for evaluating thermal neutron cross sections with molecular dynamics simulations. The cross section can be expressed with a function called as scattering law. For light and heavy water, the scattering law data instead of the cross sections have been provided in nuclear databases. In this report we review the formulations of the scattering laws. The scattering laws can be derived from both the intermediate scattering function and the space-time correlation function. Features of the derived scattering laws are briefly explained. It is shown that the scattering law data can be evaluated using a molecular dynamics simulation of the liquid that is the target of thermal neutrons.

Activation measurement for thermal-neutron capture cross-section of Cesium-135

Nakamura, Shoji; Kimura, Atsushi; Iwamoto, Osamu; Shibahara, Yuji*; Uehara, Akihiro*; Fujii, Toshiyuki*

KURNS Progress Report 2018, P. 106, 2019/08

https://www.rri.kyoto-u.ac.jp/PUB/report/PR/ProgRep2018/ProgRep2018.html

Under the ImPACT project, the neutron capture cross-section measurements of Cesium-135 (Cs) among the long-lived fission products have been performed at Kyoto University. This paper reports measurements of the thermal-neutron capture cross-section of Cs at the Kyoto University Research Reactor (KUR).

Measurements of thermal-neutron capture cross-section and resonance integral of neptunium-237

Nakamura, Shoji; Kitatani, Fumito; Kimura, Atsushi; Uehara, Akihiro*; Fujii, Toshiyuki*

Journal of Nuclear Science and Technology, 56(6), p.493 - 502, 2019/06

https://doi.org/10.1080/00223131.2019.1598304

The thermal-neutron capture cross-section()and resonance integral(I) were measured for the Np(n,)Np reaction by an activation method. A method with a Gadolinium filter, which is similar to the Cadmium difference method, was used to measure the with paying attention to the first resonance at 0.489 eV of Np, and a value of 0.133 eV was taken as a cut-off energy. Neptunium-237 samples were irradiated at the pneumatic tube of the Kyoto University Research Reactor in Institute for Integral Radiation and Nuclear Science, Kyoto University. Wires of Co/Al and Au/Al alloys were used as monitors to determine thermal-neutron fluxes and epi-thermal Westcott's indices at an irradiation position. A -ray spectroscopy was used to measure activities of Np, Np and neutron monitors. On the basis of Westcott's convention, the and I values were derived as 186.96.2 barn, and 100990 barn, respectively.